Table of Contents
Advertisement
Quick Links
ES34T
SECURITY MOTION SENSOR
•
PIR (Motion Sensor )
‚
PIR Lens
INTRODUCTION
Your EVERSPRING SECURITY MOTION SENSOR is a
fully automatic outdoor security/courtesy light controller
capable of controlling up to 1000W of lighting. At night,
the built-in passive infrared (PIR) motion sensor turns on
the connected lighting system when it detects motion in
its coverage area. During the day, the built-in photocell
saves electricity by deactivating the lights. An adjustable
timer lets you select how long the light stays on after
activation.
Two operation options - let you choose automatic
Operation or manual override based on the ambient light
level.
Note : Read this entire manual before you start to
install the system.
SAFETY PRECAUTIONS
l
Do not install when it is raining.
l
Be sure to switch off power source before installing.
l
Make sure that the power wiring comes from circuit
with an external 16A miniature circuit breaker for the
short circuit protection or a suitable fuse.
l
The unit can be installed only horizontally (see the
FIGURE 1a), not vertically (see the FIGURE 1b) as
shown in the below drawing.
HORIZONTAL
FIGURE 1a & 1b
IMPORTANT
Some local building codes may require installation of
this product by a qualified electrician.
Check your local codes as they apply to your situation.
If the house wiring is of aluminum,
consult with an electrician about proper wiring
methods.
Before proceeding with the installation, TURN OFF
THE POWER TO THE LIGHTING CIRCUIT AT
THE CIRCUIT BREAKER OR FUSE BOX TO
AVOID ELECTRICAL SHOCK.
CHOOSING A MOUNTING LOCATION
l
For the best results, fix your sensors on a solid
surface. For wall mounting, 1.8~2M above the
ground is needed. For ceiling mounting, 2.5~4M
above the ground is required.
l
For outdoor installation, a location under eaves is
preferable.
l
Avoid aiming the motion sensor at pools, heating
vents, air conditioners or objects which may change
temperature rapidly.
l
Do not allow sunlight to fall directly on the front of
unit.
l
Try to avoid pointing the unit at trees or shrubs or
where the motion of pets may be detected.
VERTICAL
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for EVERSPRING ES34T
Summary of Contents for EVERSPRING ES34T
- Page 1 PIR Lens HORIZONTAL VERTICAL INTRODUCTION FIGURE 1a & 1b Your EVERSPRING SECURITY MOTION SENSOR is a IMPORTANT fully automatic outdoor security/courtesy light controller Some local building codes may require installation of capable of controlling up to 1000W of lighting. At night, this product by a qualified electrician.
- Page 2 Prior to mounting, keep in mind that the motion Note : The detection angle of ES34T can come up to180°. sensor is most sensitive to the motion, which is However to reduce or localize its detection coverage, use across the detection field and less sensitive to the...
- Page 3 (dusk) position (FIGURE 13). mark. In this provisional setting mode, the Motion Sensor Note: For the ES34T, besides the above mentioned remains inactive during daylight. At dusk when you find it two points, you have to connect the is the LUX level desired for operation, simply set the LITE ‘YELLOW/GREEN’...
- Page 4 Protection Class Class II Waterproof IP44 Operating By using wall switch to your ES34T, you can easily Temperature -20° C to +40°C select one of two modes of operation: automatic Up to 12m (39.4ft) at 20° C, operation and manual override.
Need help?
Do you have a question about the ES34T and is the answer not in the manual?
Questions and answers