Silvercrest SBTF 10 C2 Operating Instructions Manual page 12

Position the hands-free appliance and the mobile tele-
phone so that they are not more than 1 metre away
from each other.
Press and hold down the multi-function button 6 for 6
seconds until, after 3 seconds a short, high signal tone
and after a further 3 seconds a succession of low and
high signal tones are heard. The LED status indicator
7 lights up constantly and the hands-free equipment is
now in the coupling mode.
Select the hands-free provision "Car Kit" from the list of
available appliances for the mobile telephone.
Enter in the pre-programmed passcode "9999" and
then confi rm it, which couples the appliances with each
other. You will hear a long high signal tone and the
LED status indicator 7 blinks every 3 seconds.
You can now use the hands-free appliance.
Note:
When using the latest mobile phones, (Smartphones) those
that are equipped with Bluetooth
ern version, it is possible that the pass code "9999" need
not be entered. If the coupling is not completed within 2
minutes, the hands-free appliance switches itself off . The
LED status indicator 7 extinguishes and you will hear a
long and deep signal tone. With some mobile telephones
it is possible that coupling does not automatically take
place. In this case coupling must be carried out addition-
ally on the mobile telephone. The LED status indicator 7
blinks twice every 3 seconds until this has been carried
out. Further information can be found in your mobile
telephone's operating instructions.
SBTF 10 C2
2.0 or a more mod-
®
GB
CY
9