Operations; Basic Operations - Clarion DXZ7ZS Owner's Manual

Note: Be sure to read this chapter referring to the front diagrams of
chapter "3. CONTROLS" on page 5 (unfold).
Basic Operations
Be sure to lower the volume before switch-
ing off the unit power or the ignition key. The
unit remembers its last volume setting. If you
switch the power off with the volume up,
when you switch the power back on, the sud-
den loud volume may hurt your hearing and
damage the unit.
Adjusting the volume
1. Press the front part of the knob to adjust. The
knob will pop up.
2. Turning the [ROTARY] knob clockwise in-
creases the volume; turning it counterclock-
wise decreases the volume.
*
The volume level is from 0 (minimum) to 33
(maximum).
DXZ725
13
Switching the display
Press the
[0]
button to select the desired display.
Each time you press the
[0]
button, the display
switches in the following order:
Main display
~
Main display
*
Once selected, the preferred display becomes
the display default. When a function adjust-
ment such as volume is made, the screen will
momentarily switch to that function's display,
then revert back to the preferred display sev-
eral seconds after the adjustment.
*
When you have entered a title in a CO/MO, it
appears in the main display. If you have not
entered a title,
"[Q]
NO-TITLE" or
"rn
NO-
TITLE" appears in the title display instead. For
information on how to enter a title, refer to the
subsection "Entering titles" in section "Op-
erations Common to Each Mode".
23
23
/.{:?:a
~
Ff'l I
98
IOfi:Jf>3
:::;T fJ{}····T.Z·TI... ·.E:·
~
Ff'll 9810fi:Jf>3
Clock display
Turning on/off the power
Note:
• Be careful about using this unit for a long time with-
out running the engine. If you drain the car's battery
too far, you may not be able to start the engine and
this can reduce the service life of the battery.
1. Press the [FNC] button.
2. The illumination and display on the unit light
up. The unit automatically remembers its last
operation mode and will automatically switch
to displCG' that mode.
3. Press and hold the [FNC] button for 1 second
or longer to turn off the power for the unit.
Note:
• System 6heck
The first time this unit is turned on after the wire
connections are completed, it must check what
equipment is connected. When the power is
turned on, "SYSTEM CHCK" and "PUSH
POWER" appear in the display alternately, so
press the [FNC] button. The system check starts
within the unit. When the system check is com-
plete, the power is turned off, so press the [FNC]
button again.
Selecting
a
mode
1. Press the [FNC] button to change the opera-
tion mode.
2. Each time you press the [FNC] button, the op-
eration mode changes in the following order:
Radio mode
-+
DAB mode
-+
SIRIUS mode
-+
CD male
-+
DVD deck mode
-+
CD
changer mode
-+
MD changer mode
-+
DVD
changer mode
-+
TV mode
-+
AUX mode
-+
Radio mode...
*
External equipment not connected with
CeNET is not displayed.
*
A Digital Radio (DAB) program can be re-
ceived only in Canada.
*
The SIRIUS mode can be also switched using
the [SAT] button.