Curtis CGC Service Manual page 21

Cleaning the Brew Cones
Clean the dispensing spout of the brew cone once a month or more often in locations where
the unit gets heavy use.
1. Look into the brew cone to locate the cap covering the spout tube. Remove this cap
by grasping the top portion and pulling it straight up.
2. Clean the inside orifice of the spout tube. For better cleaning, you can mix a mild
dish washing solution to use while cleaning. Insert a small brush through the spout
tube from the outside of the brew cone. Spin the brush a few times to remove any
coffee residue.
Look inside the brew cone and verify that the brush has gone completely through
the spout.
3. Clean the small opening on the side of the spout tube. Insert the brush into the side
opening and spin it a few times. Run the brush completely through the side opening.
4. Rinse the brew cone with clear water. Observe the flow of water from the dispensing
spout to make sure you have a good flow. Cover the spout tube with the cap.
Rough-In Drawings
CGC Twin Head Brewer
11.63"
(29.5 cm)
18.25"
(46.4 cm)
10.13"
(25.7 cm)
CGC1 Single Head Brewer
11.63"
(29.5 cm)
18.25"
(46.4 cm)
10.13"
(25.7 cm)
11.13"
(28.3 cm)
6.88"
7.38"
7.25"
(17.5 cm)
(18.7 cm)
(18.4 cm)
Cup Clearance
11.13"
(28.3 cm)
6.88"
7.38"
7.25"
(17.5 cm)
(18.7 cm)
(18.4 cm)
Cup Clearance
21.13"
(53.7 cm)
21.13"
(53.7 cm)
13.25"
(33.7 cm)
15.25"
(38.7 cm)
13.25"
(33.7 cm)
15.25"
(38.7 cm)
21