Table of Contents
Advertisement
installation guide (continuous)
reset
The reSeT button is located behind the front
panel and can only be accessed with the front
panel opened. resetting the unit will erase
the time and preset memories. It should only
be activated upon initial installation after all
wiring is complete, or if there is a malfunction
of any of the switches on the unit. In these
circumstances, pressing the reSeT button
will clear the system and return the unit to
default operation.
Fuse
When replacing a fuse, make sure the new
fuse is the correct type and amperage. Using
an incorrect fuse could damage the radio.
reconnect Battery
When wiring is complete, reconnect the
battery negative terminal.
anti-theft system
This unit is equipped with a detachable panel.
Panel can be detached and taken with you,
helping to deter theft.
removing the panel
1. Switch off the power of the unit.
2. Press
button to flip down the panel.
3. At an angle hold the panel to pull it out.
installing the panel
1. Hold the panel and ensure the panel faces
toward you, and set the right side of the
panel in the panel bracket.
2. Press the left side of the panel until it locks.
removing the unit
1. remove the panel and the trim plate.
2. Remove the trim ring by firmly grasping one
side and pulling.
3. Insert the removal keys straight back until
they lock, then pull the radio out. If the
removal keys are inserted at an angle, they
will not lock properly and will not release the
unit.
12
Advertisement
Table of Contents
