Midtronics PowerSensor Micro500 Instruction Manual page 15

Battery/ starting/charging system analyzer
Table of Contents

Advertisement

REPLACING THE MICRO500 BATTERY
The Micro500 uses a 9-volt battery to allow testing batteries down to 1
volt. When the battery requires replacing, the display shows "Low
Internal Battery, Replace" when you connect to a battery.
You should change the battery as soon after the message is displayed
as possible.
NOTE: The analyzer will retain setup information while you change the
9-volt battery.
IMPORTANT: The Micro500 can test down to 5.5 volts when the internal
9-volt battery is not functioning.
1.
Remove the cover to the battery compartment using a small
screwdriver.
2.
Insert a 9-volt battery as shown below, making sure the positive
and negative terminals are positioned correctly.
3.
Put the cover onto the compartment and tighten the screw.
14

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PowerSensor Micro500 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents

Save PDF