Advertisement
Connect your
garage door
operator to the terminals of relay 1
(COM and
NO) it's normally the 2
wires running to a manual push button which can open the door. If your button is wireless there are
normally 2 terminals in the operator which can be connected to.
For connecting to
electronic locks and keeps
connect to relay 1
COM and NC
or
COM and NO
depending on the whether the lock is constantly energised or only energised to activate it (check
with your lock manufacturer or installer if unsure about the connections)
Connect your existing
doorbell
button wires to the terminals of relay 2
(COM and
NO)
You can now slide the front panel back onto the receiver. This is the reverse of removal as
mentioned earlier. Slide all the way back and squeeze together at the ends until they click into place.
Now link the 2 units together by plugging in the shielded RJ45 cable from the call station into the
RJ45 socket of the internal receiver.
Connect the antenna and roll out its cable and place in a position of good signal reception.
Plug in the supplied power adaptor and switch it on.
Advertisement
