Download Print this page

Celius CEL-iN1 Setup And Installation Manual

Door mount gsm intercom

Advertisement

Quick Links

CEL-iN1 Door Mount GSM Intercom
Read the whole manual before you begin
Setup and Installation
Fitting the external call station
Using the back cover of the external call station as a template, mark the positions of the fixing and
cable holes onto the door frame with a marker. The top and bottom fixing holes can be started with
a bradawl or small pilot holes can be drilled. The large cable hole in between them will require a
16mm (5/8") hole to be drilled through the frame at a slightly upward angle. Make sure you remove
the back cover from the frame before drilling the hole, only use it as a template. When all holes are
drilled offer the back cover up to the frame and fix with the 2 screws provided.

Advertisement

loading

Summary of Contents for Celius CEL-iN1

  • Page 1 CEL-iN1 Door Mount GSM Intercom Read the whole manual before you begin Setup and Installation Fitting the external call station Using the back cover of the external call station as a template, mark the positions of the fixing and cable holes onto the door frame with a marker. The top and bottom fixing holes can be started with a bradawl or small pilot holes can be drilled.
  • Page 2 Now feed the cable of the call station front panel through the hole and very slowly and evenly slide It is very important that top and bottom edges of the front it onto the back cover. panel are gently spread and offered onto the back cover evenly as there is little flexibility in the front panel with the sealed internal cover welded to the back of it The assembly is of a screwless design and is held together when the grooves at the rear clip in...
  • Page 3 Connect your garage door operator to the terminals of relay 1 (COM and NO) it’s normally the 2 wires running to a manual push button which can open the door. If your button is wireless there are normally 2 terminals in the operator which can be connected to. For connecting to electronic locks and keeps connect to relay 1...
  • Page 4 However if you need this option it is available on request. Programming Door Opening Authorisation Numbers (This permits which phones will be able to call the CEL-iN1 and open the door at any time) Send this message to the sim in the unit...
  • Page 5 To open the door without being on a call you can just call up the CEL-iN1 which will reject the call but will activate relay 1. Calling the unit again will close the door. This is useful in situations where you go to check on your camera after a delivery and realise you have mistakenly left the door open.
  • Page 6 Switch 1 turned on allows the CEL-iN1 to call your phone for 13 seconds before hanging up (this is to prevent it from going to your voicemail if you don’t answer. Switch 1 turned off allows the CEL-iN1 to call your phone for 20 seconds before hanging up (this is...
  • Page 7 Next to the sim holder is the speaker volume control which is tested and pre-set before dispatch to almost maximum which we have found to be the perfect setting. The unit has an echo cancellation function activated which detects and corrects voice repeat (common on speakerphone operated devices).