How To Mount - Boyo VTR113 User Manual

How to mount

There are two ways to mount vehicle camera recorder.
1.
You can use windshield suction cup to mount on to the windshield. If
you preferred to use windshield suction mount, please locate the right
place for you and use the lever to lock the position on to the windshield.
When the suction cup has been mounted on the windshield, please
slide the #17 base-clip on to the suction cup mount and adjust VTR113
for the desired position.
2.
If you prefer to permanently mount it using double sided tape, please
peel off one side of the tape and attach it to the #17 base-clip. Then peel
off the other side of the tape and mount it to a safe location area on the
windshield
Powering Method
There are two ways to power the VTR113. You can power the DVR using
the cigarette plug or the OBDII connector if the vehicle is equipped.
1.
Power using OBDII connector
A. The OBD II port is typically located inside the vehicle above
A. Insert OBDII connector on to the OBD II port of the vehicle and
2.
Power using car charger
B.
C.
D. The VTR113 will power up and start recording automatically
the brake pedal, under the steering wheel. Please see vehicle
user's manual if you cannot locate OBD II port)
connect power wire between power adapter and VTR113.
Insert the cigarette car charger plug into the cigarette lighter
socket in the vehicle.
Connect the power cable to the car charger and power port to
VTR113 USB port.
when the car starts.
3