Reef Crest Random Mode; Additional Modes; Lagoonal Random Mode - Vortech MP10 Setup Manual

Reef Crest Random Mode

Reef Crest Random Mode simulates a high-energy reef
environment. It is indicated by both a yellow control
dial and the first two blue LEDs illuminated. The control
dial is used to set the maximum pump speed during
this mode. The pump will change speed frequently and
drastically to simulate crashing waves and surging tide.

Additional Modes

All modes are set to default duration,
speed or percentage of speed. Refer
to the full manual to learn how to
customize these modes.
1 6
FEED MODE
Press and hold the MODE
button for 3 seconds to
enter Feed Mode. The
control dial will blink white and the
pump will spin very slowly for 10
minutes (default setting) and then
resume its set mode.

Lagoonal Random Mode

Lagoonal Random Mode simulates a low-energy
lagoon environment. It is indicated by a yellow control
dial and the third and fourth LEDs illuminated. The
control dial is used to set the maximum speed of this
mode. The speed of the pump is changed slowly to
recreate the gentle currents of a lagoon.
BATTERY BACKUP MODE
When a Battery Backup
accessory is added to the
VorTech pump, the pump will
automatically switch to Battery Backup
Mode during a power outage. The pump
will run at the minimum speed to maximize
run time during this critical period.
NIGHT MODE
Press and hold the MODE and
SET buttons, pause, and then
press and hold the MODE and
SET buttons again. The control dial will
breathe white and spin at 50% power for
10 hours (default setting), and then resume
its set mode.
17