Vortech MP10 Setup Manual page 5

Installing the VorTech
Continued
STEP 6: Attach Wet Side
•
Place the wet side into the aquarium and allow ALL air
to escape from the propeller housing.
•
Carefully align the wet and dry sides through the glass
(Figures D).
•
Optional: Place the foam guard over the wet side of
the pump. The foam guard can be used to ensure that
delicate marine animals do not get caught in the nozzle.
Figure D
6
™
STEP 7: Align Pump
•
•
•
•
Plug the power supply into the driver. If the pump is not
already in Constant Speed Mode, press the MODE button
until the control dial is green.
If there is vibration or excessive noise, carefully adjust the
propeller housing (wet side) by moving it very slightly left,
right, up or down until the noise/vibration is eliminated
or minimized (Figure E).
Rotate the control dial clockwise
and set it to the maximum speed,
indicated by the blue LEDs.
Press the MODE button to select
the mode of your choice and
then turn the control dial to the
desired flow rate.
See page 9 for instructions on mounting the driver.
Figure E
7