Short Pulse Mode; Gyre Mode - Vortech MP10 Setup Manual

Short Pulse Mode

When first entering Short Pulse Mode, set the
maximum pump speed with the control dial and
press the SET button to lock it. The LEDs will
begin to ramp, indicating the pulsing frequency
between 0.2 seconds and 2 seconds. Next, use
the control dial to adjust the pulse frequency.
Press and hold SET until the control dial flashes
and then breathes blue, indicating the wave
is saved.
AUTO TUNE
Auto Tune allows you to create a wave within your tank.
To create a wave using Auto Tune, Hold SET and OPTION
MAKE WAVES
until LEDs move back and forth slowly. Press and hold SET
WATCH THE VIDEO:
1 4
1 4
until the control dial flashes and then breathes blue, indicating
ecote.ch/qdmakewave
When first entering Gyre Mode, set the maximum pump
speed with the control dial and press the SET button
to lock it. The LEDs will begin to ramp, indicating the
pulsing frequency between 2 seconds and 2 hours.
Next, use the control dial to adjust the pulse frequency.
The first six LEDs represent 2 seconds to 2 minutes.
The seventh through 12th LEDs represent 5, 10, 20, 60,
90 and 120 minutes, respectively. Press and hold SET
until the control dial flashes and then breathes pink,
indicating the wave is saved.
that the wave has been saved. This saved wave will
also be used in EcoSmart mode. To fine tune the
wave, press MODE to speed up the wave and OPTION
to slow it down. Press SET to save the wave.

Gyre Mode

AUTO TUNE
WATCH THE VIDEO:
15 15
ecote.ch/qdautotune