Table of Contents
Advertisement
Connect to PC or Hub/Switch.
For connecting to 10Base-T Ethernet or 100Base-TX or 1000Base-T
Fast Ethernet / Gigabit Ethernet cabling. This Ethernet port built
auto-negotiation protocol can detect or negotiate the transmission
speed of the network automatically. Please use CAT-5 or above cable to
RJ-45
connect the Network Camera to a 100/1000Mbps Fast/Gigabit Ethernet
(LAN socket, PoE )
network switch.
The input power is DC 12V, 1A.
12VDC in & Power
GND
MIC in
Connect an external microphone to the camera.
(Audio in)
Connect a loud speaker to the camera. This function is for voice alerting
Audio out +/-
and two-way audio.
Connect a TV monitor to the camera. User can check the focus/zoom
Video out
and view angle of the camera.
The 6 pin terminal block includes 1 input port and 1 output port, and
DI/GND/DO/RS485
RS-485 D+ and D-.
This button is used to restore the all factory default settings.
Restore the device:
Factory Default
a. Press the button down continuously.
Reset
b. Hold the button at least 5 seconds and release it. Then the device has
been restored to default settings and reboot again.
Micro SD Card Slot
User can insert a micro SD card into this slot for recording.
That to cabling this camera by type of connector board, firstly, user must remove the
attached "connector cable" from wafer 1~ 6 shown as below:
5 Mega-Pixel 20M IR Vari-Focal Dome IP Camera
ONLY use one power source, either from DC or from
802.3af Power over Ethernet.
ONLY use package power adapter supplied with the
internet. Otherwise, the product may be damaged.
17
ICA-4500V
Advertisement
Table of Contents
