Ad Notam Display Frame Unit DFU-0133 User Manual page 17

It is possible to program every single key (except for the
WATERPROOF with an individual IR command from a teaching remote control of another IR controlled device.
Programming procedure:
1. Place the IR remote control WATERPROOF (learning) and your external device remote control (teaching) "head to
head", approximately 30cm apart, as shown below:
teaching remote control
2. To enter the "learn mode" press and hold the To enter the "learn mode" press and hold the
action for more than 30 seconds the remote control will exit "learn mode" automatically!
3. Press and release a key you wish to program on the learning remote. The LED indicator still lights constantly.
4. Press and release a key you want to capture on the teaching remote. The LED indicator starts to blink slowly
indicating the IR command has been captured.
5. To save this IR code press and release again the key you wish to program on the learning remote. The LED indicator
blinks fast and then lights constantly to indicate this IR code has been saved.
6. To program more keys please repeat steps 3 - 5 while in "learn mode". To program more keys please repeat steps 3 - 5 while in "learn mode". To program more keys please repeat steps 3 - 5 while in "learn mode".
7. To exit "learn mode" please press and release the To exit "learn mode" please press and release the
In order to reset all keys to ad notam "factory default" IR commands, please follow the next steps: In order to reset all keys to ad notam "factory default" IR commands, please follow the next steps: In order to reset all keys to ad notam "factory default" IR commands, please follow the next steps:
1. Press and hold the Press and hold the and and and
2. Press and release the Press and release the
3. The LED indicator will turn off and the remote control has been reset to the initial IR codes.
adress change procedure:
1. Please note: dfU ir address should be changed previously! dfU ir address should be changed previously! dfU ir address should be changed previously!
2. Press and hold the Press and hold the and
3. Press and release a sequence of tree numeric keys (address codes "000" to "255" are available).
IR command
key until the LED indicator lights constantly. Please note: With no
keys simultaneously until the LED indicator lights constantly.
key three times in sequence to enter the code "999".
keys simultaneously until the LED indicator lights constantly.
key itself) of the learnable IR remote control
learning remote control
key again. The LED indicator is off.
17