iDataLink Maestro Rr Install Manual page 58

INSTALLATION INSTRUCTIONS
STEP 1
• Remove the factory radio.
• Access the main 22 pin factory radio connector (2.1) and
determine if you have a factory amplifi er.
If you have wires in PIN 7, 8, 9 and 10, you don't have a
factory amplifi er.
If you don't have wires in PIN 7, 8, 9 and 10, you have a
factory amplifi er.
1 2 3 4
12 13 14 15 16 17 18
Fig. 2.1
• Unbox the aftermarket radio and locate its main harness.
• Connect the wires shown on the next page from
aftermarket radio main harness to the CH2 T-harness and
match the wire functions.
STEP 2
• Connect the factory harness to the CH2 T-harness.
STEP 3
• Access the OBDII connector located under the driver side
dashboard.
• Connect the BROWN /RED wire of the CH2 T-harness to
the wire located at pin 6 of the OBDII connector. (See the
vehicle wire chart reference for wire colors)
• Connect the BROWN /YELLOW wire of the CH2 T-harness
to the wire located at pin 14 of the OBDII connector. (See
the vehicle wire chart reference for wire colors)
STEP 4
• Plug the aftermarket radio harnesses into the aftermarket
radio.
• Plug the Data cable to the data port of the aftermarket
radio.
• Insert the Audio cable into the iDatalink 3.5 mm audio jack
of the aftermarket radio.
Automotive Data Solutions Inc. © 2015
5 6 7 8 9 10 11
19 20 21 22
STEP 5
• Connect all the harnesses to the Maestro RR module then
proceed to module setup.
The module is now ready to be used.
Insert the aftermarket radio in the dashboard housing and
test all the functionalities.
Reassemble the dashboard carefully.
TROUBLESHOOTING TIPS:
• To reset the module back its factory settings, turn the key
to the OFF position then disconnect all connectors from
the module. Press and hold the module's programming
button and connect all the connectors back to the module.
Wait, the module's LED will fl ash RED rapidly (this may
take up to 10 seconds). Release the programming button.
Wait, the LED will turn solid GREEN for 2 seconds.
• For technical assistance call 1-866-427-2999 or e-mail
"support@idatalink.com". Visit us at "maestro.idatalink.
com/support" and "www.12voltdata.com/forum/"
1
ADS-RR(SR)-CHR01-DS
JeeP Patriot Base 2007-2008
3
maestro.idatalink.com