Fueling Instructions - Gasoline Vehicles - Club Car Golf Car Series Owner's Manual

Fueling Instructions – Gasoline Vehicles
13. Remove the dipstick and add engine oil into the dipstick port. Use a funnel or pour spout to direct the oil into the
dipstick port. With filter change, the engine requires 38 ounces (1.12 L) of oil per change. Refer to oil viscosity
guidelines for selection of oil grade (Figure 36). Replace the dipstick.
14. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles on page 14.
15. With the Forward/Reverse handle in the NEUTRAL position, run engine for 3 minutes and check for leaks.
Observe both the drain plug and the oil filter from under the vehicle and watch for oil leaks. If filter leaks, tighten
additional 1/4 turn and retest. If oil drain plug leaks, re-torque and retest.
16. Remove the dip stick and check the engine oil as a final step. Replace the dip stick.
27
Figure 35 Coat Oil Filter Rubber Seal
FUELING INSTRUCTIONS – GASOLINE VEHICLES
See General Warnings on page 12.
DANGER
• Turn the key switch to the OFF position before fueling.
• Do not pour fuel into the fuel tank when the engine is hot or while it is running.
• Be sure the fuel tank ground wire, located next to the fuel shut-off valve, is properly connected before
fueling the vehicle.
• To avoid electric arc caused by static electricity, the fuel storage/pumping device must be grounded. If
the pump is not grounded, the vehicle must be grounded to the pump before and during the fueling
operation.
• If the vehicle has an all-weather enclosure installed, be sure the fuel tank is properly vented as shown
(Figure 24, Page 36).
• To avoid the possibility of fire, clean up any spilled fuel before operating the vehicle.
CAUTION
• To allow for expansion, do not fill higher than one inch (2.54 cm) from the top of the fuel tank. Avoid
spilling fuel.
Page 56 Precedent Gold Standard Remanufactured Vehicle Owner's Manual
SAE 10W-30/ SAE 10W-40
SAE 5 W-30
213
Figure 36 Oil Viscosity Chart
SAE 30