Table of Contents
Advertisement
The LED indicators 4 or 5
do not light up
The charge control LEDs 4 and 5 respectively, do
not light up after inserting the mains plug into the
socket.
Possible causes of trouble are:
– The charger plug has not been (properly) in-
serted.
Corrective measure: Insert the plug (fully)
into the socket.
– A defective socket, cable or charger.
Corrective measure: Check the mains volt-
age and, if necessary, take the charger to an
authorized customer service center for Bosch
power tools so it can be checked.
Practical Advice
After continuous or several repetitive charging
cycles, the charger could warm up. However,
this temperature increase is no cause for con-
cern, as it does not indicate a technical defect
in the unit.
A battery that is new or has not been used for
a longer period does not develop its full capac-
ity until after approximately 5 charging /dis-
charging cycles. Leave such batteries in the
charging compartment until they have clearly
warmed up.
A significantly reduced working period after
charging indicates a used up battery that must
be replaced.
6 • 1 609 929 F80 • TMS • 05.05.04
Maintenance and Cleaning
The unit is maintenance free. Always keep the
unit and the ventilation slots clean.
Should the unit fail in spite of the care taken dur-
ing its manufacturing and testing, take it only to a
customer service center for Bosch power tools to
be repaired.
In all correspondence and spare parts orders,
please always include the 10-digit order number
given on the nameplate of the unit.
Environmental Protection
Recycle raw materials instead of disposing
them as waste
The unit, accessories and packaging should be
sorted for environmental-friendly recycling.
These instructions are printed on chlorine-free re-
cycled paper.
The plastic components are labeled for catego-
rized recycling.
English - 3
Hide quick links:
Advertisement
Table of Contents
