Table of Contents
Advertisement
Valet Mode
Valet mode can be entered and exited by performing the Remote Valet
command or manually using the vehicle key and the control button.
When entered, the alarm functions are defeated while the conve-
nience features still operate normally.
Arm and Disarm commands lock and unlock the doors while the
I~_~~ text a nd beeps play to confi rm.
Use the following steps to manually enter and exit Valet Mode:
1.
Turn
the ignition switch On and then Off
2.
Immediately
press
and
release
the control button once
3.
The control center LED turns On when entering and Off when
exiting.
Power Save
To reduce power consumption the control center status LED modifies
its output if the vehicle is parked for an extended period.
If
Armed the
flashing is reduced after 24 hours. When Valet mode is On the LED
will turn off 1 hour and will reset each time the ignition is turned off.
Rapid Resume
If
power is ever disconnected by a mechanic or thief, the system will
resume the state it was in at the time of disconnection, when power
is recon nected .
Automatic Remote Updates
The system sends a silent message to all remote controls after any
major action has occurred. When the remote receives this message it
updates the status screen icons. This way all users are able to quickly
review the system status just by accessi ng the status screen.
©
2009 Directed Electronics. All rights reserved.
41
Advertisement
Table of Contents
