Valet Mode; Power Save; Rapid Resume; Car Select - Python 44606P Owner's Manual

Valet Mode

Valet mode can be entered and exited by performing the Remote Valet
command or manually using the vehicle key and the control button.
Use the following steps to manually enter and exit Valet Mode:
Turn the ignition switch On and then Off
1.
2. Immediately press and release the control button once
3. The control center LED turns on when entering and off when exit-
ing.

Power Save

To reduce power consumption the control center status LED modifies
its output if the vehicle is parked for an extended period. If Locked the
flashing is reduced after 24 hours. When Valet mode is On the LED
turns off after 1 hour and resets each time the ignition is turned off.

Rapid Resume

If power is ever disconnected by a mechanic or thief, the system will
resume the state it was in at the time of disconnection, when power
is reconnected.

Car Select

Car 2 remote control option must first be turned On (see under "Re-
mote Control Configuration" on page 12 to turn on). Press and
hold the
button for 3 seconds. The LED flashes once or twice to
indicate the selected Car is 1 or 2, release the button for Car Select
or continue to hold for programming.
Release the
es continue to perform Car Select. Once the car is selected a com-
mand can be performed by pressing one of the command buttons.
22
AUX
AUX
button, then press and release while the LED flash-
© 2016 Directed. All rights reserved.