Advertisement
2.
ATTACHMENT OF FRONT FENDER
Tools required – 10mm & 8mm wrenches or adjustable wrench
Using a 10mm wrench or an adjustable wrench, remove the locknut from the front brake mounting bolt, this is the thicker
nut on the end (2-A). Insert the fender through the rear of the fork and the brake caliper. Position the fender with the brake
mounting bolt through the fender mount (2-B). Carefully thread the locknut onto the brake mounting bolt. While holding
the brake caliper in position, tighten the locknut.
Locknut
Brake mounting
bolt
mounting
bolt
2-A
Using an 8mm wrench or an adjustable wrench, remove the fender mounting bolts (3-A) on the fork and use them to
attach the fender struts.
3.
FRONT WHEEL INSTALLATION
Tool required – 15mm wrench or adjustable wrench
Loosen the outer silver nuts on each side of the wheel axle enough for the fork to fit over the axle with a silver nut and
washer on the outside of the fork on each side (3-B). With the tire tread in the same direction as the rear wheel, center
the tire between the brake pads and push the tire through the brake. Position the wheel axle between the fork blades so
that the axle seats firmly at the top of the slots of the fork dropouts (3-A).
3-A
QUESTIONS: Should you have any questions during the final assembly of your new bicycle, please call our product 11/19/13
specialists at 800-226-7552 any day between 8:00 a.m. and 10:00 p.m. Eastern.
Fork dropout
Fender mounting
bolt
Fender
mount
Fender strut
2-B
3-B
Brake
caliper
Silver nut and
washer on the
outside of the
fork
pg.3
Advertisement
