Advertisement
6. ATTACHMENT OF SADDLE TO SETPOST
Required tool- 13mm wrench or adjustable wrench
Use a 13mm or adjustable wrench to loosen the seat clamp nut (6-A) enough to slide the small end of the seat post into the
seat clamp. Ensure that the smaller end of the seat post is fully inserted into the seat clamp (6-B). Snug the clamp nut.
6-A
Seat clamp nut
To install the seat post to the bike, open the quick release seat clamp or loosen clamp bolt if not a quick release (6-C).
Insert the seat post into the bike's seat tube past the minimum insertion line, this line is embossed into the lower portion
on the seatpost (6-C). The saddle is adjustable forward and back along the saddle rails and can be angled up or down. The
best starting position is with the saddle horizontal and in the middle of the saddle rails (6-D). With the bike on the ground
find this position and tighten the seat post clamp nuts.
6-C
QUESTIONS: Should you have any questions during the final assembly of your new bicycle, please call our product 11/19/13
specialists at 800-226-7552 any day between 8:00 a.m. and 10:00 p.m. Eastern.
Seat clamp
Saddle set
horizontal
Minimum
insertion
line
6-B
Saddle mounted correctly
6-D
pg.6
Advertisement
