Advertisement
1. FRONT WHEEL
Required tools – 15mm wrench or adjustable wrench
Position the fork so that it is facing forward (1-A). Remove the outside 15mm nut and safety washer from each side of
the axle. Slide wheel axle into the slots at the bottom of the fork. Place a safety washer on each side of the axle. The
smaller end of the washer should be facing the fork (1-B). Ensure that the narrow portion of the safety washer is seated
fully into the rounded portion of the fork dropout. Carefully thread on a 15mm nut to each end and tighten with a
wrench.
1-A
2. INSTALL TRAINING WHEELS
Required tools – two 13mm wrenches, 15mm or adjustable wrench
Remove the training wheels, brackets, and training wheel bolts from the parts box. Remove the locknut and washers
form the training wheel bolt. Slide the bolt through the training wheel. Place one washer on the bolt next to the wheel.
Insert the training wheel and bolt through the wheel slot on the bracket. Place the second washer on the bolt and
carefully thread the locknut on. Tighten the lock nut with two 13mm wrenches or adjustable wrenches. Repeat the
process with the other training wheel and bracket.
2-A
QUESTIONS: Should you have any questions during the final assembly of your new bicycle, please call our product 3/6/14
specialists at 800-226-7552 any day between 8:00 a.m. and 10:00 p.m. Eastern.
Fork in
correct
forward
position
Dropout
portion
of fork
Wheel
slot
Training
wheel bolt
1-B
Training wheel
correctly
mounted to
bracket
2-B
Safety
washer
and 15mm
nut in
proper
position
pg.2
Advertisement
