HP Compaq nc4000 Series Maintenance And Service Manual page 118

Removal and Replacement Procedures
3. Remove the following screws:
❏
❏
❏
❏
4. Use a 5.0-mm socket to remove the two M2.0×9.0 standoffs
5 that secure the system board to the base enclosure.
Removing the System Board Screws
5–44
Two T8M2.0×6.0 screws 1 from the rear panel
One T8M2.0×4.0 screw 2 in the upper right corner of the
system board
One T8M2.0×4.0 screw 3 in front of the hard drive bay
One T8M2.0×4.0 screw 4 in the lower left corner of the
system board
Maintenance and Service Guide