Table of Contents
Advertisement
OVEN ASSEMBLY
TO BE INSTALLED BY A QUALIFIED TECHNICIAN KNOWLEDGEABLE WITH WOOD FIRED
COOKING APPLIANCES
7.
Dry assemble the oven at a convenient location to
ensure a proper fit. Assemble the oven sections
sequentially. Refer to the illustration to the right.
8.
Place the hearth section(1) at the desired location
on top of the 3" heat stopper board. Mark this
location incase the base is accidentally moved.
Make sure that the heat stopper surface is level.
If the shelf is not level you may add sand to level
the hearth.
9.
Squeeze adequate amount of fireplace mortar
evenly on the seam of section (1). Be certain that
the base is in its marked location and fit the
pieces together.
10.
Push the hearth section(2) tightly against section(1) as shown in the illustration below. Wipe away
any excess mortar from the surface with a damp towel. Do not move the hearth thereafter.
11.
Set dome section(3) in place; apply the fireplace mortar to the applicable outer edge of
hearth generously. Refer to the illustrations below.
©Wildwood Ovens and BBQs LLC 2009
WWW.WILDWOODOVENS.COM
11
323.255.6587
All specifications subject to change without notice
Milano
Wood Fired Oven
Installation Instructions
Version 4.0
Advertisement
Table of Contents
