Troubleshooting; Replacement Parts/Accessories - Bissell HARD FLOOR EXPERT 1161 User Manual

Troubleshooting

Problem Possible causes
Motor not Check that the plug is connected
operating
to the socket securely
Full dust cup
Dusty filter(s)
Weakened
Clog in the hard floor tool or hose
suction power
Variable suction set to the lowest
speed
Power cord The power cord may pile on one
cannot be
side of the coiler
rewound
completely
Power cord
Power cord may be twisted
cannot be
pulled out
Batteries may be bad
Infrared remote
Bad infrared connection
control failure
Vacuum not
The main power switch on the
turning on with vacuum body was not turned on
remote control
REPLACEMENT PARTS
Handle
Assembly
160-2083
Pre-motor
filter / Pleated
160-2084
filter
Pre-motor
filter /
160-2085
Foam filter
Post-motor
filter / Foam
160-2094
P
ost-motor
160-2086
filter /
Unwoven cloth
Tool Holder
160-2087
Dirt Tank
160-2088
Other maintenance or service not included in the manual should be
Please do
performed by an authorized service representative.
not return
Thank you for selecting a BISSELL product.
this product
For any questions or concerns, BISSELL is happy to be of service.
to the store.
Contact Consumer Care listed on page 8.
Remedies
Re-plug
Empty dust cup
Check and clean or replace filters
Follow instructions E3 on page 6 for
cleaning the hard floor tool.
Press the "+" on the remote to dial up
the suction
Pull out a large section of the cord
and rewind it
Press the REWIND button and rewind
or pull out the cord repeatedly
Replace batteries
Make sure the infrared lights are not
hidden and are visible
Turn on the power on the base of
the canister, which will activate the
remote control
WARNING
To reduce the risk of electric shock, turn power switch off
and disconnect polarized plug from electrical socket before
performing maintenance or troubleshooting checks.
ACCESSORIES
Carpet Tool
160-2089
Hard Floor Tool
160-2090
Telescopic
Extension Wand
160-2091
Crevice Tool
160-2092
Upholstery Tool
160-2093
7