Door Replacement; Water Pipe Installation; Water Connection Instruction Guide - LG LSC27931 Series Owner's Manual

Move the
Refrigerator
Before
Installation
WARNING
Connecting
the Refrigerator
to a Water Source
Tools Required
Screwdriver
Electric drill
9
Adjustable wrenches
Push the refrigerator sideways through the
entrance door as shown in the right picture.

Door replacement

Mount the doors in the reverse order of
removal after the refrigerator is brought to
the installation area.
NOTE:
Check the direction of the level hinge.
Correct
Feed water tube installation
Automatic icemaker operation needs water pressure of 21.3~121psi(lb/inc h
is, a 7oz. paper cup will be lled within 3 sec.).
If water pressure does not reach the rated 21.3psi(lb/inc h
to purchase a separate pressure pump for normal automatic icemaking and cool
water feed.
Keep the total length of the water feed tube within 40 feet and be careful not to
bend or kink the tube. If the tube is longer than 40 feet, the icemaker and water
dispenser will not operate properly.
Install the water feed tube at a place free from heat.
Connect to potable water supply only.
Refer to instructions with water lter kit for installation.

Water Connection Instruction Guide

Read all directions carefully before you begin.
IMPORTANT
If operating the refrigerator before installing the water connection, turn icemaker
•
to theOFF position to prevent operation without water.
All installations must be in accordance with local plumbing code requirements.
•
Use copper tubing and check for leaks.
•
Install copper tubing only in areas where temperatures will remain above freezing.
•
It may take up to 24 hours for your icemaker to begin producing ice.
•
Standard screwdriver
7/16-inch and 1/2-inch open-end wrenches or two adjustable wrenches
1/4-inch nut driver
1/4-inch drill bit
Hand drill or electric drill (properly grounded)
NOTE
Your refrigerator dealer has a kit available with a 1/4-inch saddle-type shut-o valve,
•
a union, and copper tubing. Before purchasing, make sure a saddle-type valve
complies with your local plumbing codes. Do not use a piercing-type or 3/16-inch
saddle valve which reduces water ow and clogs more easily.
Incorrect
Installation
) (That
2
) or below, it is necessary
2