Table of Contents
Advertisement
Pass the
Pass the refrigerator laterally through the
access door as shown in the right figure.
refrigerator
Door replacement
Mount them in the reverse sequence of removal after they pass through the
access door.
Feed water pipe installation
Before
Automatic ice maker operation needs water pressure of 147~834 kPa
installation
(1.5~8.5 kgf/cm
3 sec.).
If water pressure does not reach the rating 147 kPa (1.5 kgf/cm
necessary to purchase a separate pressure pump for normal automatic icing and
cool water feed.
Keep the total length of the feed water pipe tube within 8 m and be careful for
the tube not be bent. If the tube is 8 m or longer it may cause trouble in water
feed owing to the drain water pressure.
Install the feed water pipe tube at a place free from heat.
Connect to potable water supply only.
WARNING
Refer to instructions with water filter kit for installation.
IMPORTANT : Use only new hose-sets supplied whit the appliance and do not
16
2
) (That is, an instant paper cup (180 cc) will be fully filled within
reuse old hose-sets.
Installation
5
Max
4
3
TEMP
FRZ
2
2
Min
1
1
3
REF
TEMP
4
5
Max
2
) or below, it is
Advertisement
Table of Contents
