Taillamps
1. Open the endgate.
2. Remove the two screws
from the lamp assembly.
3. Pull the assembly away from the vehicle.
4. Turn the socket counterclockwise
to remove it. Push
the tab in while you turn the socket
counterclockwise.
5. Holding the base of
the bulb, pull the bulb straight
out of the socket.
6.
Push the new bulb straight into the socket until
it clicks.
7. Put the socket into the lamp assembly and turn the
socket clockwise until it locks into place.
8. Install the lamp assembly and screws.
9. Close the endgate.
Underhood Lamp
1.
2.
3.
4.
5 .
6.
7 .
8.
Disconnect the electrical connector from the
underhood lamp assembly.
Remove the screws.
Disconnect the ground wire.
Remove the lamp assembly from the hood.
Install the new bulb.
Replace the assembly. Install and tighten the screws.
Connect
the
ground wire.
Connect the electrical connector to the
lamp assembly.