Dismounting The Bearings Of The Inner Scraper Arm - Wittenborg FB 5100 Service Manual

Service Manual FB50/55/5100/5500

9.2.13 Dismounting the Bearings of the inner Scraper Arm

Unscrew the nut (1). (Fig. 1)
Remove the spring washer (2). (Fig. 1)
Unscrew the bearing neck (3) from the
inner scraper arm by means of a 10 mm
socket wrench. (Fig. 1)
Remove the guiding washers (4) and the
ball bearing (5) from the bearing neck.
(Fig. 1)
Mounting instructions:
- The grained surfaces of the guiding
washers have to point towards the ball
bearing
- Fasten the bearing neck (10 mm socket
wrench) in such a manner that the outer
bearing ring can be turned. Check by
means of a screw driver
- Mount the locking ring.
22
Dismounting/Repair Brewing System
3
4
5
6
Fig. 1
1
2
November, 1998