Table of Contents
Advertisement
Configuring the Camera
Sensor AOI Left
- As shown in Figure 4 on
AOI, i.e., how far the sensor AOI will be offset from the left edge of the sensor. When you adjust this
setting, you will notice that it must be changed in certain fixed increments. *
Sensor AOI Top
- As shown in Figure 4 on
AOI, i.e., how far the sensor AOI will be offset from the top edge of the sensor. When you adjust this
setting, you will notice that it must be changed in certain fixed increments. *
Sensor AOI Width
- As shown in Figure 4 on
When you adjust this setting, you will notice that it must be changed in certain fixed increments. *
Sensor AOI Height
- As shown in Figure 4 on
AOI. When you adjust this setting, you will notice that it must be changed in certain fixed
increments. *
* You can also use the Sensor AOI Editor (see
make to the AOI parameter settings on the Global tab will be reflected on the Sensor AOI Editor.
Image Rotation
- Sets the degrees of rotation for the images captured by the sensor.
0° = Don't rotate the images.
180° = Rotate the images 180 degrees.
Image Mirror
- Enables or disables image mirroring.
Off = Image mirroring is disabled.
Horizontal = Horizontal mirroring is enabled. (The image will be flipped left to right.)
Vertical = Vertical mirroring is enabled. (The image will be flipped top to bottom.)
Both = Horizontal and vertical mirroring are both enabled.
22
Frame Rate Mode
- Sets the rate at which the camera's sensor will
capture frames (images). For example, selecting 30 FPS means that
the camera's imaging sensor will capture 30 frames per second.
Note that on some camera models, typically those with large
imaging sensors, the maximum rate at which the sensor can capture
images (i.e., the frame rate) is limited. On these cameras, if you
decrease the height of the sensor AOI, the rate at which the sensor
can capture images will increase. So if you decrease the setting for
the AOI Height parameter, you may see an increase in the
maximum setting available for the Frame Rate Mode parameter.
page
21, sets the left offset (in pixels) for the sensor
page
21, sets the top offset (in pixels) for the sensor
page
21, sets the width (in pixels) of the sensor AOI.
page
page
21, sets the height (in pixels) of the sensor
24) to set this parameter. Any changes you
Basler IP Fixed Dome Cameras
AW00101504000
Advertisement
Table of Contents
