Cisco 1600 series Quick Start Manual page 5

Install the Router (continued).
B. Install the WAN interface card.
Look for a WAN interface card in the slot on the right-rear of the router, just above the slot labeled FLASH PC
CARD. (There is no WAN interface card installed if there is a metal plate over the slot.) If the card is already
installed, connect it to your WAN line according to the instructions that came with the card. To install a card,
follow the instructions below.
Note: You must provide a Phillips
screwdriver for this step.
Step 1
Confirm that the power is OFF.
Step 2
Remove the thumbscrews that hold
the slot cover in place, and then remove the
slot cover.
Step 3
Hold the card by the edges and line it
up with the guide on the card slot.
Step 4
Insert the card into the slot and push
in until it is firmly seated in the connector and
the front panel is flush with the router rear
panel.
Step 5
Tighten the screws that are in the
card.
Connect the card port to the WAN line
according to the instructions that came with
the card.
5