Cisco 1600 series Quick Start Manual page 4

Install the Router (continued).
A. Connect the router to the local networks.
The router has three Ethernet ports, but supports only two Ethernet connections at one time. Connect the router
to your local Ethernet networks in one of these ways:
Option 1:
Connect the ETHERNET Ø 10BASET port and the ETHERNET 1 10BASET port.
Option 2:
Connect the ETHERNET Ø AUI port and the ETHERNET 1 10BASET port.
Option 1
You need two RJ-45-to-RJ-45 cables and two
Ethernet hubs or switches for this option.
Step 1
Connect one end of the first cable to the
yellow ETHERNET Ø 10BASET port, and connect
the other end to a network port on the hub or switch.
4
LNK LED
Step 2
Connect the second cable to the yellow
ETHERNET 1 10BASET port as described in Step 1.
LNK LED
Option 2
You need one RJ-45-to-RJ-45 cable, one AUI cable,
and an Ethernet transceiver for this option. If the
transceiver connects directly to the router, you do
not need the AUI cable.
Step 1
Connect the Ethernet transceiver to the
yellow ETHERNET Ø AUI port, and connect the
transceiver to the local network.
Step 2
Connect one end of the RJ-45 cable to the
yellow ETHERNET 1 10BASET port, and connect
the other end to a network port on the hub or switch.
LNK LED