Table of Contents
Advertisement
Soundcraft SX Series User Guide V1.0
3. SX SERIES CONTROLS
19- MASTER AUX SENDS CONTROLS
These six controls are used to determine the master AUX SEND levels,
which can be varied from - ∞ to +15 dB. When the external effect units
which have no input gain control were connected to mixer, you can get
a further +15 dB gain available from these AUX Send outputs.
20- SOLO Button
The function of these SOLO buttons are the same as the channel SOLO
button, they can also be affected by the SOLO MODE switch. Press the
SOLO button, the corresponding AUX send will be routed to the Control
Room/Phones outputs and Meters display.
21- MASTER STEREO AUX RETURNS CONTROLS
These four controls set the level of effects that received from the stereo
AUX RETURN connectors, which can be varied from - ∞ to +15 dB. They
are used to provide the further gain for low level effects.
22- TO AUX SEND1/2
The both rotary knobs assign the AUX RETURN signals to their respec-
tive AUX SEND outputs: The "TO AUX SEND1" assign the signal from AUX
RETURN1 to AUX SEND1 bus, and "TO AUX SEND2" assign the signal from
AUX RETURN2 to AUX SEND2 bus. The adjustable range goes from - ∞ to
+15 dB.
23- SUB1-2/SUB3-4/MAIN L-R/CENTER BUTTONS
These two groups of buttons are configured for AUX RETURN3/4, they can be regarded as the
signal assignment switches. For example, When engaging the SUB1-2, the stereo signal from
AUX RETURN3 will be assigned to Sub-group1/2; In the same way, SUB3-4 for Subgroup3/4,
MAIN L-R for MAIN L-R buses.
24- MATRIX A&B
These controls will allow the sound engineer to address SOURCES SIGNAL to SUB1,SUB2,SUB3,
SUB4,MAIN L,MAIN R , CENTER.
25- 2TK LEVEL & TOMIX BUTTON
By rotate the knobs, you can adjust the stereo signals level of 2TK input and engaging the
switch allows you to combine the 2-Track output with the Main Mix. In other words, feeds the
2- Track In signals into Main L/R output.
26- SUBGROUPS ASSIGN TO MAIN MIX
Through these switches, you can operate the subgroup faders as a master control for assigning
the subgroups to MAIN MIX.
27- POWER LED
The LED indicates when the power is ON.
28- LED METER
The stereo 16-segment LED Meter will indicate the signal level send to the Control Room and
Phones outputs.
29- SOLO ACTIVE
This LED indicates that the one or more SOLO button have been activated. When this LED is
on, the METERS indicates the level of the signal of the selected channel or mixer section in AFL
mode.
11
Advertisement
Table of Contents
