Specifications - Sony DWA-F01D Operating Instructions Manual

Specifications

Audio section
Analog output connector
XLR-3-32 type
(OUTPUT 1/OUTPUT 2)
Analog output impedance
150 ohms or less
Digital output connector
BNC-R
AES3-id output impedance
75 ohms
WORD SYNC IN connector
BNC-R, 75 ohms (when the
DWR-S01D is attached to the
adapter and 75-ohm
termination is added)
OUTPUT 1/2 connector
φ 3.5 mm TRS jack
OUTPUT 1/2 level (MIC LEVEL selected)
–52 dBu
OUTPUT 1/2 level (PHONES selected)
50 mW (16-ohm load, at
T.H.D = 1%)
General
Power requirements
12 V DC (DC IN)
7.2 V DC (battery)
Operating voltage
10 V DC to 17 V DC (DC IN)
6 V DC to 8.4 V DC (battery)
Maximum continuous operation
Approx. 5 hours
(ambient temperature of 25 °C
(77 °F), fully charged Sony
NP-F570 lithium-ion battery,
OUTPUT 1/2 unused,
DWR-S01D CH1/CH2 ON,
wireless remote control function
OFF, auto switch for display set
to AUTO DIMMER)
14 Specifications
Operating temperature
0 °C to 50 °C (32 °F to 122 °F)
Storage temperature
20 °C to +60 °C (
–
Dimensions
(unit: mm (inches), excluding protrusions)
9
39 (1 / ) 142 (5
16
Mass Approx. 400 g (14 oz)
(excluding receiver and battery)
Supplied accessories
DC power cable
(for 4-pin connector) (1)
Operating Instructions (1)
Warranty booklet (1)
CD-ROM (1)
Optional accessories
LCS-F01D soft carrying case
Design and specifications are subject to
change without notice.
Note
Always verify that the unit is operating
properly before use. SONY WILL NOT
BE LIABLE FOR DAMAGES OF ANY
KIND INCLUDING, BUT NOT
LIMITED TO, COMPENSATION OR
REIMBURSEMENT ON ACCOUNT OF
THE LOSS OF PRESENT OR
PROSPECTIVE PROFITS DUE TO
FAILURE OF THIS UNIT, EITHER
DURING THE WARRANTY PERIOD
OR AFTER EXPIRATION OF THE
WARRANTY, OR FOR ANY OTHER
REASON WHATSOEVER.
4 °F to +140 °F)
–
5
/ )
8