Pin Code; Conductivity - Miele TKB 350 WP Operating Instructions Manual

Programmable functions
 PIN Code
The code prevents your machine
being used without your knowledge.
When the code has been activated, you
have to enter a code after switching the
dryer on. Otherwise the dryer cannot be
operated.
Options
 Factory default: off
 Code on
If option  has been selected, after
switching on you will have to enter the
code before you can operate the dryer.
Using the dryer when the code is
activated
After the dryer is switched on,  will
flash in the time display.
The code is  and cannot be altered.
 Touch the  sensor until a 
flashes in the first position.
 Confirm this by pressing the Start/
Stop button.
 Enter the two other numbers in the
same way.
The dryer is ready for use after  has
been entered and confirmed.
68
 Conductivity

This setting should only be
altered if the water is so soft that it is
likely to cause the electronics which
sense residual moisture in the
laundry to give false readings.
Important
This option should not be activated if,
despite the water being extremely soft
(as would be the case if a water
softener were used), its conductivity is
greater than 150 μS/cm.

Only activate this programmable
function for the conditions described
above.
Otherwise drying results can be
unsatisfactory.
Options
 Factory default: off
 Low conductivity