Advertisement
NOTE: Make sure that you have the heater or air conditioner turned on before leaving your vehicle. The
unit will warm or cool your car when starting by remote control.
If the vehicle was armed, remember to disarm the system and unlock the doors with the unlock button,
before entering the vehicle.
DRIVING-OFF
After having disarmed the system and unlocked the doors, enter the vehicle and do the following:
1. Turn the ignition key to the ON position. (Do not turn it to the start position, since the engine is
already running.)
2. Press the brakes to disengage the remote starter unit. You are now ready to drive off.
REMOTE TRUNK RELEASE
If your unit was installed with the trunk release option, you can open the trunk using your remote. This is
especially handy when you carry packages and need to open the trunk.
Press and hold the Trunk button together until the parking lights flash once. To open the trunk, you then
press the TRUNK Button again within 3 seconds until you see the parking lights flash again. You can
also press the TRUNK button continuously for 3 seconds to accomplish the same task. The parking lights
stay ON while you press the TRUNK buttons.
REMOTE STARTER VALET AND ALARM VALET MODES
The alarm/starter unit can be placed in Remote Starter Valet Mode to disable the capability of starting
the engine by the unit while maintaining the alarm and door locking/unlocking functions. This is
recommended if the vehicle is to be parked in a garage or if the vehicle needs to be serviced.
The alarm/starter unit can also be switched to Alarm Valet Mode to stop an alarm condition or to disable
the alarm functions and the anti-theft starter kill feature. While in the Alarm Valet Mode, the remote
starting capability, the panic mode and door locking/unlocking functions are still operational.
NOTE: Enabling Alarm Valet Mode is required if you want to stop the initial alarm condition that
occurs when powering-up the system.
Using one of the next options will permit the user to place the alarm/starter in any one of the following
combinations using the single valet switch:
Normal operation
Alarm valet mode only (Starter, Trunk and Locks still work)
Starter valet mode only (Alarms, Trunk and Locks still works)
Alarm and starter valet modes (Locks and Trunk still work)
ENABLING ALARM VALET MODE.
Start with Valet switch in the OFF position.
1. Turn ignition ON and wait for two seconds.
2. Slowly set the valet switch from OFF to ON. At this point the LED turns and stays ON to indicate that
the Alarm Valet Mode is enabled
3. Turn the ignition OFF and turn the Valet switch back to OFF.
DISABLING ALARM VALET MODE.
Start with Valet switch in the ON position.
Turn ignition ON and wait for two seconds.
1.
2. Slowly set the alarm valet switch from ON to OFF. At this point the LED turns and stays OFF to
indicate that the Alarm Valet Mode is disabled.
3. Turn ignition OFF
5
Page
Advertisement
