Download Print this page

Remaining In Ready Mode; Remote-Starting; Vehicle Presets; Driving Off - Nordic Start NS-1084HF User Manual

Advertisement

d.
TRUNK

Remaining in Ready Mode

Once the vehicle is in Ready Mode you can start and stop the vehicle at wish. However, if
any one of the following events occurs, the vehicle will exit Ready Mode – thus eliminating
the remote start option until Ready Mode is restored:
Door opened;
Hood opened;
Brakes pressed;
Parking Brake disengaged;
Key turned to the
Should any of the above occur, Ready Mode will be cancelled.
Note: The unit will notify the user that it has exited Ready Mode by giving three slow flashes
of the vehicle's Parking Lights.

Remote-Starting

Press the
START/STOP
you that the unit has received your signal. Approx. 5 seconds later, the engine will start. The
Parking Lights will remain ON during the pre-programmed run time.
If the vehicle doesn't start the first time, the system will shut down, wait a few seconds, and
try to start the engine again. It will try to start the engine 3 times before giving up.

Vehicle Presets

Heater and Heated Seat
When leaving the vehicle it is recommended to preset the accessory controls in preparation
for the next remote start. Settings for the blower motor (fan), front and rear, as well as
heated seats (if equipped) should not be left on
on
or
instead.
LOW
MEDIUM
Windshield Wipers, Radio and Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to
become energized while running under remote start. When leaving the vehicle you must
ensure that the windshield wiper and headlight switches are
switch
on certain types of vehicles could cause them to remain
ON
starter shuts down, resulting in a dead battery.

Driving Off

With the vehicle running under remote control, press the
the doors (if installed). Enter the vehicle and do the following:
Turn the ignition key to the
Press the brakes to disengage the remote starter unit.
You are now ready to drive off.
Caution: do not turn the key to the
the starter motor to re-engage, unless your vehicle is equipped with the Start Kill / Anti-
Grind Feature (Optional).

Idle Mode

This feature allows the user to engage the remote starter to take over the vehicle while it is
already running with the key in the
programmed run time, or until it is shut down by remote.
Caution: Do not leave children or pets unattended in a car running in Idle Mode.
To activate Idle Mode:
User Guide
to lock all Doors and engage idle mode.
IGNITION ON (RUN)
button for approx. 1 second. The parking lights will come ON, informing
IGNITION ON (RUN)
CRANK
IGNITION
position.
. It is recommended to leave the settings
HIGH
UNLOCK
position.
position with the engine running. This will cause
switch. The vehicle will keep running for the pre-
. Leaving the headlight
OFF
even after the remote
ON
button to
and
DISARM
UNLOCK
P. 3

Advertisement

loading