Download Print this page

Introduction; Basic Remote Operation; Remote-Starting Your Vehicle; Vehicle Presets - Nordic Start NS-1014 User Manual

Automatic transmission multi-channel remote starter system

Advertisement

Introduction

This module is a state-of-the-art remote car starter system. With many advanced function,
this product will satisfy any one of the user's expectations from high-end commodity systems,
without neglecting the standard features commonly offered by entry-level starters.

Basic Remote Operation

Your remote car starter can operate two independent vehicles equipped with an identical
remote car starter (see multi-car operation on page 6).
The functions of the transmitter are as follows:
Pressing the
LOCK

Remote-starting Your Vehicle

Press the
START/STOP
you that the unit has received your signal. Approx. 5 seconds later, the engine will start. The
parking lights will remain
If the vehicle doesn't start the first time, the system will shut down, wait a few seconds, and
try to start the engine again. It will try to start the engine 3 times before giving up.

Vehicle Presets

Heater and Heated Seat
When leaving the vehicle it is recommended to preset the accessory controls in preparation
for the next remote start. Settings for the blower motor (fan), front and rear, as well as
heated seats (if equipped) should not be left on
on
or
instead.
LOW
MEDIUM
Windshield Wipers, Radio and Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to
become energized while running under remote start. When leaving the vehicle you must
ensure that the windshield wiper and headlight switches are off. Leaving the headlight switch
ON on certain types of vehicles could cause them to remain on even after the remote starter
shuts down, resulting in a dead battery.

Driving Off

With the vehicle running under remote control, press the
the doors (if installed). Enter the vehicle and do the following:
Turn the ignition key to the
Press the brakes to disengage the remote starter unit.
You are now ready to drive off.
P. 2
and
buttons simultaneously will activate the
UNLOCK
button for approx. 1 second. The parking lights will come
during the pre-programmed run time.
ON
IGNITION ON (RUN)
. It is recommended to leave the settings
HIGH
button to
UNLOCK
position.
output.
AUX 2
, informing
ON
and
DISARM
UNLOCK
User Guide NS-1014

Hide quick links:

Advertisement

loading