Advertisement
In either mode, you can arm or disarm your alarm system using your remote control and if your system was
installed with remote door locks, you can lock or unlock your doors at the same time.
NOTE: The alarm functions can be used and are active in the same way whether the engine is running
under the remote or not. In other words, your vehicle benefits from high security protection at all times.
ARMING AND LOCKING DOORS
PASSIVE ARM MODE
In Passive Arming Mode, the system will arm itself automatically after the completion of a 35 second
arming delay (LED flashes quickly) initiated after the last door of the vehicle is closed. Therefore, you do
not need to arm the system. The LED indicator flashes slowly when the system is armed. However, you
must lock your doors manually when leaving the vehicle.
When leaving your vehicle, perform the following:
1. Turn the Key switch OFF. The LED remains OFF.
2. Unlock if required and open the doors.
3. Once all doors are closed after exiting the vehicle, the LED will begin to flash quickly, indicating that
passive arming has begun.
Also, as long as a door is opened or if a door is opened and remains open before the completion of the
arming delay the system will not arm. (The 35 seconds countdown starts when all doors are closed)
If you want to stay in the vehicle for a certain period of time, it is recommended to have your key switch in
the ON position to avoid a situation were the system arms after somebody leaves the vehicle. While your
key is in the ON position, the system will not arm and the LED stays OFF.
ACTIVE ARM MODE
To arm the system, and lock your doors (if you have this option), press the lock button on your remote
until the siren chirps once in confirmation. Notice that the parking lights confirm the system arming by
flashing once and that the LED indicator flashes slowly to confirm the armed state. (See Chirp delete to
bypass the chirping effect).
DISARMING AND UNLOCKING DOORS
PASSIVE ARM MODE
If the system was programmed in Passive Mode, to disarm the system and unlock the doors, press and
hold the Unlock button until the siren chirps twice in confirmation. Notice also that the parking lights
confirm the system disarming by flashing twice and LED flashes quickly. Once the system is disarmed, you
have to open a door within a 35 seconds delay or else the system will rearm (LED flashing slowly) and
you set off an alarm. If the entry delay expires, you should disarm the vehicle by pressing the LOCK button
to enter the vehicle.
Once inside the vehicle, you have up to 35 seconds to turn the key switch to the ON position or start the
car to prevent the system from re-arming again. If this is not done, your system will re-arm (LED flashing
slowly) and if your system has a starter kill, you will not be able to start the car. If this situation occurs,
you need to disarm the car with the unlock button.
IMPORTANT NOTE: If your car is not equipped with a starter kill, You should not start the vehicle
if the car is armed because you may cause a false alarm.
ACTIVE ARM MODE
In Active Arming Mode, to disarm the system, unlock the doors and deactivate the starter kill if
installed, press and hold the unlock button until the siren chirps twice in confirmation. Notice also that
the parking lights confirm the system disarming by flashing twice and LED stops flashing.
Finally, note that if an alarm condition occurs and the siren is on, disarming the system will end the
alarm condition.
3
Page
Advertisement
