Advertisement
BASIC REMOTE OPERATIONS
This unit is a state-of-the-art combination of a vehicle alarm and remote starter system. Start by
familiarizing yourself with the alarm functions of the unit that you need to operate first, before using the
remote starter functions. This is especially recommended if your unit is set in Passive Arming Mode that
automatically controls the arming of your vehicle.
The Lock button is used to arm, and the Unlock button is used to disarm the alarm system and to
operate the door locks (if that option was Installed). The Trunk button control chirp delete or trunk
and the Start button is used for remote engine start
To start the car by remote, you must ensure that the Valet switch is in the ON position. Press the start
button (Lightning bolt), for about 1 second. Once the button has been pressed the parking lights will come
on to inform you that the unit has received your signal, and has begun the start process. The car should be
running after about 5 sec. The vehicles parking lights will stay on the entire pre-programmed run cycle.
NOTE: Do not continue to press the start button once the parking lights activate. Pressing the remote
continuously for 4 seconds will activate "Cold Weather Mode" and will not start the engine.
If the vehicle doesn't start, the Nordic Start will shut off, wait a few seconds, and then re-try to start the
engine again. The Nordic Start will try to start the engine a total of 2, 3 or 4 times (programmable) before
giving up.
With the vehicle running under remote control, press the Unlock button to DISARM and UNLOCK the
doors then enter the vehicle. Insert the key in the ignition and turn the key to the "ON" position. Do not
turn the key to the "START" position with the engine running, this will cause the starter motor to
reengage.
NOTE: Do not forget to leave the heather or air conditioner turned on before leaving your vehicle. So that
your vehicle can be "PRE-WARMED" or "PRE-COOLED" by remote control.
MULTI-CAR OPERATION
The NS-4503 systems feature multi-car operation. This allows the owner of two Nordic Start systems in
two of his/her vehicles to control both systems with one transmitter. (Both vehicles must be equipped with
an NS-4503.
The remote transmitter of the primary vehicle can control the starter disable system, the door locks and the
remote car starter operation of the second vehicle.
The remote transmitter of the second vehicle can also operate the primary vehicle
Second car control:
Pressing Trunk and Lock simultaneously controls lock:
Unlock is controlled by pressing Trunk and Unlock simultaneously:
Pressing Trunk and Start Simultaneously controls remote start/stop
REMOTE DOOR LOCKS
If your system was installed with remote door locks, you will have the convenience of remote keyless
entry.
To UNLOCK you doors, press and hold the Unlock button for about 1 sec. Once the doors have unlocked
the parking lights will flash twice to confirm that the doors are unlocked. (Also disarming your starter
kill.)
To LOCK your doors, press the Lock button on your remote. When the doors have locked, the parking
lights will flash once. (Arming the starter kill).
ALARM FUNCTIONS
Your installer can program your alarm/remote starter in Passive Arming Mode, so that the system
automatically arms itself when you leave your vehicle, or in Active Arming Mode, so that you can arm or
disarm your car at will.
2
Page
Advertisement
