Wiring Instructions; Operating Instructions - Delta RAD80L Instructions For Use Manual

WIRING INSTRUCTIONS

CAUTION:
• Make sure power is switched off at service panel before
starting installation.
• All electrical connections must be made in accordance with
local codes, ordinances, or national electrical code. If you
are unfamiliar with methods of installing electrical wiring,
WARNING:
• This unit must be wired on a separate 20 amp circuit.
• If your house wires do not match these colors, you must
determine what each house wire represents before
connecting and you may need to consult an electrical
contractor to determine this safely.
1. Follow all local electrical and safety codes.
2. Never place a switch where it can be reached from a tub
or shower.
3. Using wire nuts (not included), connect house power wires
to fan wires.
2
4. 14 AWG (2.1 mm ) is the smallest conductor that may be
used for branch-circuit wiring. Each power wire (light, fan,
heater) must have its own switch to operate independently.
5. For supply connections, use wire rated for at least 90ºC.
See wiring diagram for wire size.

OPERATING INSTRUCTIONS

CAUTION:
WARNING:
This unit must be properly installed before it is used. Follow instructions for cleaning, user-maintenance and
operations recommended by the manufacturer, such as lubrication or non lubrication. Any other servicing should be
performed by an authorized service representative.
1. Turn on the light switch to turn on the light bulb.
2. Turn on the vent switch to operate the fan mode.
3. Turn on the heat switch to operate the heater mode.
Model: RAD80L
LIGHT
SWITCH
HEATER
SWITCH
VENT.
SWITCH
BLK
WHT
LINE
IN
GRD
HOUSE ELECTRICAL BOX
ON/OFF SWITCH
(purchase separately)
LIGHT HEATER VENT.
SWITCH SWITCH SWITCH
ng or humming noise.
10
BLU WHT
LIGHT
(BLUE)
AWG18 AWG18
RED WHT
HEATER
(RED)
AWG14
AWG14
BLK
WHT
VENT.
AWG18 (BLACK)
AWG18
HEATER ELECTRICAL BOX
RED BLACK
BLUE
WHITE
GROUND
(bare)
SWITCH BOX
WIRING
PLATE
120 VAC
LINE IN