Table of Contents
Advertisement
MQRB5143 / MQRB6961 Surround Installation
The Surround Kits for the MQRB5143 are available in 3 different finishes:
Small [1-1/2"]
MQRB5019SBL
Surround Kits:
MQRB5019SSS
MQRB5019SPW
Each kit contains:
(Qty-1) Surround Frame
(Qty-2) Surround Side Fillers
(Qty-1) Surround Access Cover
(Qty-8) #6 Self Tapping Screws
The Surround Frames are 1" thick, with a ¾" space behind the frame. The Fireplace may be covered
up to within ½" of the opening with non-combustible materials.
Surround Installation:
1.
Note: Original Side Fillers & Valve
Access Cover will not be used.
2.
The Lower Front Face Panel must
be installed on the fireplace before
surround can be installed.
3.
Remove Glass Door from
fireplace.
4.
Hook lower ledge of Surround
Frame onto the Lower Front Face
Panel of the fireplace. With top of
Frame tilted outward, slide Side
Fillers behind Surround Frame.
5.
Push Surround Frame into place
and install using the existing screw
holes in the tile lip. Front Edge of
the Side Filler must rest between
Surround Frame and Fireplace
[see fig.2].
6.
Fasten the Side Fillers to the
fireplace using the two [2] existing
holes on either side of the firebox
opening.
7.
Replace the Glass Door and put
the new Valve Access Cover into
place with angled ends to match
Side Fillers.
*For Stainless Steel Surrounds see next page.
NOTES: Cotton gloves must be worn to protect the finish during installation and handling.
All hand and finger marks must be cleaned off with a soft cloth and light detergent prior to applying heat to the unit.
Stainless panels may discolor a little during normal operation. This is normal and should not be considered a defect.
MQRB5143
Large [4"]
MQRB5624SBL
MQRB5624SSS
MQRB5624SPW
MQRB6961
Small [1-1/2"]
Large [4"]
MQRB6919SBL
MQRB6924SBL
MQRB6919SSS
MQRB6924SSS
MQRB6919SPW
MQRB6924SPW
-Black
-Stainless Steel
-Pewter
35
Advertisement
Table of Contents
