Installation - Fiamma VERONA Installation And Operation Instructions Manual

This appliance, must be installed only in a solid-fuel burning
fireplace, with a working flue, and constructed of
noncombustible materials.
!!! IMPORTANT !!!
Before installing this appliance, have the fireplace and
chimney, professionally cleaned, to remove any ashes, soot,
creosote, or other obstructions. Perform this cleaning
annually, after installation.
FIGURE 3 VERONA BURNER SYSTEM
WHEN INSTALLING THE APPLIANCE, DO NOT OBSTRUCT THE FLOW OF COMBUSTION AND VENTILATION AIR.
LOCATION
NOTE: Verona 23" and 30" are a single Burner.
Verona 42" is A double Burner system, All
Controls and functions are the same.

INSTALLATION

Seal any fresh air vents or ash clean-out doors located on the
floor or wall of the fireplace. If this is not performed, drafting
may cause pilot outage or sooting. Use a heat-resistant
sealant; DO NOT seal the chimney flue damper.
Gas supply system must be installed in accordance with the
U.S. National Fuel Gas Code.
This appliance and its individual shut off valve must be
disconnected from the gas supply piping system during any
system pressure test in excess of ! PSI ( 3.5 KPA ).
Use a system manual shut off valve to shut off the gas supply
to this gas appliance before continuing with
procedures.
FIGURE 2
NEVER OPERATE UNIT WITHOUT MEDIA ON BURNER
The Burner May warp and will not be covered under warranty.
VERONA 42 BURNER SYSTEM FRONT VIEW
4
!!! IMPORTANT !!!
!!! WARNING !!!
VERONA 3 BURNER SYSTEM FRONT VIEW
installation