Network Setup - Samsung HT-H7500WM User Manual

Settings

Network Setup

When you connect this product to a network,
you can use network based applications and
functions such as Smart Hub and BD-LIVE, and
upgrade the product's software through the
network connection. For more information about
accessing and using Internet services, see the
Network Services chapter of this manual on pages
43~50. Instructions for configuring the
network connection start below.
Configuring your Network Connection
If you didn't configure your network connection
during the initial settings procedure or you need
to reset the network connection, follow the
directions below.
Before you begin, contact your Internet Service
Provider to find out if your IP address is static or
dynamic. If it is dynamic, and you have a wired
or wireless network, we recommend using the
Automatic configuration procedures described
below.
If you are connecting to a wired network, connect
the product to your router using a LAN cable
before you start the configuration procedure.
To begin configuring your network connection,
follow these steps:
In the Home screen, select Settings, and then
1.
press the button.
Ok
Select Network, and then press the
2.
button.
Select Network Settings, and then press the
3.
button.
Ok
Go to the instructions for Wired networks
4.
starting or the instructions for Wireless
networks starting on the next page.
Wired Network
Wired – Automatic
Ğ
After following Steps 1 to 3 above:
In the Network Settings screen, change
1.
Network type to Wired. Then, select Connect
and press the button. The product
Ok
detects the wired connection, verifies the
network connection, and then connects to
the network.
When it is done, highlight Ok, and then
2.
press button.
Ok
Wired - Manual
Ğ
If you have a static IP address or the automatic
procedure does not work, you'll need to set the
Network Settings values manually.
After following Steps 1 to 3 above:
In the Network Settings screen, change
1.
Network type to Wired. Then, select Connect
and press the
The product searches for a network, and
then displays the connection failed message.
If it is possible to connect the home cinema
✎
to your network wirelessly, select Change
Network at this point, change the Network
type to Wireless, and then go to the
instructions for wireless networks on the next
page.
Network Settings
Wired network connection failed.
Unable to connect to the network. Try the following: check if your Ip address is set
correctly in Ip Settings. Contact your Internet service provider for more information.
Change Network
Use the :; buttons to select Ip Settings,
2.
Ok
and then press the
screen appears.
Select the Ip setting field, and then set it to
3.
Enter manually.
Select a parameter to enter (Ip Address, for
4.
example), and then press Ok. Use the 78
buttons on the remote control to enter the
numbers for the parameter. Or use the Num
keypad to enter a parameter number. Press and
hold the 123 button until the Num pad appears
on the screen. When the Num pad appears,
select a number using the 78:; button
and then press the
buttons on the remote control to move from
entry field to entry field within a parameter.
When done with one parameter, press the
button.
Ok
Press the 7 or 8 button to move to another
5.
parameter, and then enter the numbers for
that parameter following the instructions in
Step 4.
Repeat Steps 4 and 5 until you have filled in
6.
all parameters.
22
- English
button.
Ok
MAC Address xx:xx:xx:xx:xx:xx
Ip Address 0. 0. 0. 0
Subnet Mask 0. 0. 0. 0
Gateway 0. 0. 0. 0
dNS Server 0. 0. 0. 0
Ip Settings Retry
button. The Ip Settings
Ok
button. Use the :;
Ok
Close