System Information; Network Setup - Samsung BD-P1400 User Manual

SYSTEM INFORMATION
When the firmware upgrade is done, check the firmware details by following the steps below.
f. With the unit in Stop mode, press the MENU button.
2. Press the AT buttons to select Setup, then press the
ENTER or _- button.
3. Press the A'v buttons to select System Upgrade, then
press the ENTER or _- button.
4. Press the Av buttons to select System Information,
then press the ENTER or _ button.
You can see detailed information about the current
firmware.
5. Press the ENTER button to select OK.
System Upgrade menu will be displayed.
NETWORK SETUP
In some rare cases, the fi rmware upgrade may not succeed.
If this occurs, you may need to set up your IPaddress, Subnet, Mask,
Gateway and DNS by following the steps below.
To setup, follow steps 1 and 3 above
4. Press the A v buttons to select Network setup, then
press the ENTER or _ button.
You will see a menu that allows you to make network
settings.
5. Press the A v buttons to select DHCP, then press the
ENTER button.
(_ '_ If DHCP isset to On,you can'tselectIPAddress, S ubnetMaskor Gateway.
'_ If DNS is setto Automatic, y oucan't selectPrimary/Secondary DNS.
Engllish 47