Wi-Fi Direct - Samsung HT-H7500WM User Manual

Settings
Select the Ip setting field, and then set it to
7.
Enter manually.
Select a network parameter to enter (Ip
8.
Address, for example), and then press
button. Use the 78 buttons on the
Ok
remote control to enter the numbers for
the parameter. Or use the Num keypad to
enter a parameter number. Press and hold the
123 button until the Num pad appears on the
screen. When the Num pad appears, select a
number using the 78:; button and then
press the button. Use the :; buttons on
Ok
the remote control to move from entry field
to entry field within a parameter. When done
with one value, press the
Press the , or . button to move to another
9.
parameter, and then enter the numbers for
that parameter following the instructions in
Step 8.
10. Repeat Steps 8 and 9 until you have filled in
all parameters.
You can get the Network parameter values
✎
from your Internet provider.
11. When finished, select Ok, and then press the
button. The Security screen appears.
Ok
12. On the Security screen, enter your network's
security code or pass phrase. Enter letters by
selecting a letter with the 78:; buttons,
and then pressing the
13. When finished, select done at the right of
the screen, and then press the
The product verifies the network connection
and then connects to the network.
14. After the home cinema verifies the network,
select Ok, and then press the
You can also begin the Manual Network setup
✎
by going to Settings > Network > Network
Status.
WpS(pBC)
Ğ
One of the easiest ways to set up the wireless
network connection is using the WpS(pBC)
function. If your wireless router has a WpS(pBC)
button, follow these steps:
After following Steps 1 to 3 in "Configuring Your
Network Connection" on page 22:
In the Network Settings screen, change
1.
Network type to Wireless. The product
searches for and then displays a list of the
available networks.
Scroll the list down, select WpS(pBC), and
2.
then press the button.
Ok
button.
Ok
button.
Ok
button.
Ok
button.
Ok
24
- English
Press the WpS(pBC) button on your
3.
router within two minutes. Your product
automatically acquires all the network
settings values it needs and connects to your
network after the network connection is
verified.
When it is done, highlight Ok, and then
4.
press the button.
Ok
For a WPS connection, set your wireless
✎
router's security encryption to AES. WEP
security encryption does not support a WPS
connection.

Wi-Fi Direct

The Wi-Fi direct function allows you to connect
Wi-Fi direct devices to the product and each other
using a peer-to-peer network, without a wireless
router.
Some Wi-Fi direct devices may not support
✎
the AllShare function if connected via Wi-Fi
direct. If this is the case, change the network
connection method you used to connect the
device to the home cinema.
Wi-Fi direct transmissions can interfere
✎
with Bluetooth signals. Before you use the
Bluetooth function, we strongly recommend
that you turn off the Wi-Fi direct function on
any device in which it is currently on.
Turn on the Wi-Fi direct device and activate
1.
its Wi-Fi direct function.
In the Home screen, select Settings, and then
2.
press the button.
Ok
Select Network, and then press the
3.
button.
Select Wi-Fi direct, and then press the
4.
button.
The Wi-Fi direct devices that you can connect
the home cinema to appear.
Settings
Wi-Fi direct
device Name : [HTS]H7500WM
Select your Wi-Fi direct device to connect to.
AndroidXXXXXXX
Ok
Ok
Disconnected
Refresh
Close