Preparations; Attaching A Lens; Adjusting The Flange Focal Length - Sony HDC3300R Operation Manual

l AUDIO IN CH1 and CH2 connectors (XLR 3-pin)
and switches
Connect audio signals. An input select switch and
microphone power switch are provided for each channel.
CH1 audio input select switch
Microphone power switches
CH2 audio input select switch
FRONT MIC
LINE MIC LINE
48V
OFF
AUDIO IN
CH 1
AUDIO IN CH1 connector
CH1 audio input select switch
Set to the appropriate position according to the equipment
connected to the AUDIO IN CH1 connector.
LINE: When a line-level (0 dBu) signal source is
connected
FRONT MIC: When using the microphone connected to
the MIC 1 IN connector
MIC: When an external microphone is connected
CH2 audio input select switch
Set to the appropriate position according to the equipment
connected to the AUDIO IN CH2 connector.
LINE: When a line-level (0 dBu) signal source is
connected
AES/EBU: When a digital audio signal is connected. (The
signal must be in synchronization with the camera
output.)
MIC: When an external microphone is connected
Microphone power switches
When a microphone is connected to the corresponding
AUDIO IN connector, set whether or not to supply a power
to the microphone.
+48V: To supply a power of +48 V
OFF: Not to supply a power
(No function has been assigned to the lowermost position.
No power is supplied to the microphone.)
Note
In the case of supplying +12 V, contact a Sony service or
sales representative.
AES/EBU
MIC
48V
OFF
CH 2
AUDIO IN CH2 connector

Preparations

Attaching a Lens

For information on handling lenses, refer to the lens'
operation manual.
Attaching procedure
5
1
Push the lens fixing lever upwards and remove the lens
mount cap from the lens mount.
2
Align the lens' alignment pin with the notch in the
upper part of the lens mount and insert the lens into the
mount.
3
While supporting the lens, push the lens fixing lever
downwards to secure the lens.
4
Connect the lens cable to the LENS connector.
5
Secure the lens cable with the cable clamp.

Adjusting the Flange Focal Length

Adjustment of the flange focal length (the distance
between the lens mount attachment plane and the imaging
plane) is necessary in the following situations:
• The first time a lens is attached
• When changing lenses
• When zooming and the focus is not sharp at both
telephoto and wide angle
The flange focal length can be more precisely adjusted by
using the focus assist indicators.
See "Displaying the focus assist indicators" on page 23
for the focus assist indicators.
2 4 1,3
Preparations
15