Table of Contents
Advertisement
TROUBLE SHOOTING
WARNING
Disconnect power before performing any maintenance and allow to cool before servic-
SYMPTOM
Fireplace doesn't work,
but "F" visual alarm light
is flashing.
or log set and ember is not
glowing.
Remote Control does not
work.
Circuit Breaker trips or fuse
blows when the unit is on.
Ember Bed is not glowing or
dimming.
No warm air coming from
appliance
not turn on.
Appliance will not come on
ON.
POSSIBLE CAUSES
Fireplace inner temperature over
LED Light(s) burt out or wiring is
loose.
LED Light(s) are burnt out.
LED Light(s) are burnt out.
Room temperature is higher than
or MED).
a. Appliance has overheated and
mal switch to disconnect.
OR
b. House circuit breaker has
tripped.
a. Appliance is not plugged into
an electrical outlet.
OR
b. Appliance has overheated and
mal switch to disconnect.
CORRECTIVE ACTION
a.This fireplace are include a visual alarm and a thermostat
limiter safety device to warn/prevent that parts of heater are
power to the unit. Reset it by turning the main power switch
back ON/Plug in the unit.
trip repeatedly contact a qualified service technician.
if necessary. Inspect light bulbs and replace if necessary.
there may have been a loss of power to the unit as a pos-
sible result from a power failure
(i.E. Breaker tripped).
to ensure it is on a dedicated circuit with proper amp. rat-
or replace wiring and/or connectors as necessary.
Inspect the LED Light(s) and replace them if necessary.
Inspect the LED Light(s) and replace them if necessary.
a. Unplug the appliance, allow appliance to cool for 15 min-
-
utes, then plug back in.
b. Reset the house circuit breaker
a. Check plug and plug it in.
b. Unplug the appliance, allow appliance to cool for 15 min-
-
utes, then plug back in.
24
Advertisement
Table of Contents
