English LC-Display PMR-Operation Radio-Operation Main Screen Main Screen Appears if normal PMR status is activated or if Vox is switched on. Appears if key lock function is activated Indicates the actual condition of the batteries. Indicates receiving signals or for transmitting mode. Indicates the selected PMR channel 1 - 8.
English Setting up the TEAM Talk & Radio TR-446 1) Inserting the batteries: Turn the unit in that way that the rear panel lies in front of you. Rotate the belt clip a quar- ter turn counter-clockwise, so that the battery compartment lid is accessible now. The locking of the battery compartment lid is located at the bottom side of the unit.
English Note: The On/Off operation of the confirmation and On/Off key ( 5 ) is disabled after the last activation. This factory setting has been made to avoid an unwanted On/Off switching of the unit. The disabling of the On/Off function will be cancelled after the key ( 5 ) is not pressed for at least 2 seconds.
English speaker ( 6 ), and the key symbol appears in the display. Now all keys except the PTT key( 9 ) are ignored. The speaker gives two short tones at every pressure on any locked key, except the confirmation key ( 5 ). To stop the key lock function depress and hold the confirmation key ( 5 ).
English 8) Battery indication: In case of completely charged batteries the battery symbol is filled-in. At 5.1 V sup- ply voltage one third of the filling disappears, at 4.7 V one other third, and at 4.1 V there is only the frame remaining. Now it is time to change or charge the batteries or accus, otherwise errors of functions and displayed information may occur.
English 1) Channel selection: To select a channel depress out of the keys ( 4 ) Down ▼ 9 times or Up ▲ once. The display shows the writing . Then depress briefly the confirmation and On/Off key ( 5 ). Then the display shows the writing , where the “8“...
English can be changed in the wanted direction in a ring like system. Press the confirmation key ( 5 ) to select the desired code number, and the display will return to the main screen of the PMR mode. If the code number is different from zero, it will be visible in the PMR main screen at the position ( F ).
English the writing with one or several points or bars. The number of those points or bars shows the actual setting of the squelch sensitivity level. The more points or bars appear, the lower the level can be for opening the squelch. By the help of the Up/Down keys ( 4 ) this setting can be changed and watched in the display.
Page 13
English you see the microphone symbol now. This indicates that the VOX function is active now. If you talk loud enough into the microphone Mic ( 7 ), a short tone comes from the speaker and in the display you see at the position ( D ) the symbol .
English At the highest or lowest value you hear a triple confirmation tone. Press the confirmation key ( 5 ) to select the desired setting of the sound level threshold, and the display will return to the main screen of the PMR mode. 6) Selection of the call melody: To select a call melody depress out of the keys ( 4 ) Down▼...
English number. This is the main screen for PMR monitor operation. In this condition you can only adjust the volume level setting ( Para 3 ) or the squelch sensitivity setting ( Para 4 ). This can be done by the help of the Up/Down keys ( 4 ). To adjust the volume level of the repro- duction of incoming signals depress out of the keys ( 4 ) Down ▼...
English on every occupied channel, where the squelch opens, for 10 seconds. If there is in the demodulated signal also a CTCSS tone, it will show also the corresponding CTCSS code number. 10 seconds later or after the signal has dropped below the squelch threshold the channel scan function continues searching.
English Radio operation of the TEAM Talk & Radio TR-446: With the help of the toggle switch PMR/RADIO ( 8 ) you can switch the unit between two types of operation PMR operation and radio operation. The actual mode is indicated by the actual main screen.
English 2) Volume adjustment: To adjust the volume level of the reproduction of incoming signals depress out of the keys ( 4 ) Down ▼ 3 times or Up ▲ 2 times. The display shows . Then depress briefly the confirmation key ( 5 ). Then the display shows .
English channel so that he can choose between PMR operation or FM radio operation. To select the desired return mode put the arrow on one of both writings and then depress the con- firmation key ( 5 ). In the case that you have selected the setting “Auto“ ( = automatic return ), and the unit receives a signal, there will be a short tone from the speaker and the display will show the main screen of the PMR mode.
English In transmission mode keep the unit in a vertical position at a distance of 2 to 3 inches from your face. Keep the antenna at a distance of at least 1 inch away from your head and your body. If you carry the unit on your body and if the unit is in transmit mode, make sure that the antenna is kept at a distance of at least 1 inch away from your body.
Page 22
• France • Germany • Greece • Luxembourg • Netherlands • Portugal • Spain• Sweden • Switzerland • U.K. Nachdruck oder Vervielfältigung auch Auszugsweise nur mit ausdrücklicher Genehmigung von TEAM Electronic GmbH. TEAM Electronic GmbH Bolongarostrasse 88 electronic D-65929 Frankfurt / Main...
Need help?
Do you have a question about the Talk & Radio TR-446 and is the answer not in the manual?
Questions and answers