D-Link DKVM-IP1 User Manual page 20

Notes:
BOOTP is a static configuration protocol that uses a table that maps IP

addresses to physical addresses.
DHCP is an extension of BOOTP that dynamically assigns configuration

information. DHCP is backwards compatible with BOOTP.
The factory default settings for the DKVM-IP1 unit are as below:
DHCP: Disabled
Default IP address: 192.168.0.70
Default Subnet mask: 255.255.255.0
IN SHORT: If the currently selected device has DHCP selected for its Network
Configuration, click OK and the DKVM-IP1 will try to contact a DHCP server in the
network to which it is physically connected. If contact is made with a DHCP server, it will
provide the DKVM-IP1 with a dynamic IP address, gateway address and subnet mask.
NB: Changing your device's password through the DKVM-IP1 Utility:
To change your password with the DKVM-IP1 Utility, select your device from the Device
MAC Address drop-down box, then in the "Authentication" section in the bottom-left part
of the window, enter the Super User login and current password for your DKVM-IP1. The
default login is super, and the default password is pass. Now enter your new password
in the "New Super User password" text box, and enter it again in the "New Password
(confirm)" text box to confirm it.
19